Hardware Settings; Plc Settings - Fuji Electric Monitouch V9 Series Connection Manual

1.4

Hardware Settings

Select and set the devices to connect to the V9 series on the Hardware Setting screen.
1.
2. Connection Diagram
3.
Ethernet unit switch
4.
Other Setting switch
5. MONITOUCH Settings
1.4.1

PLC Settings

To enable communication with a PLC, a temperature controller, an inverter, etc., the following settings are required to be set
on the editor. You can see the contents of these settings in the V9 Local mode.
For information on Local mode, refer to the V9 Series Troubleshooting/Maintenance Manual.
1. 2.
4.
5.
Item
Set the devices (PLC, temperature controller, servo, inverter, barcode reader etc.) to connect to
PLC Setting
PLC1 to PLC8.
The devices which are set for connection are displayed.
Devices as well as communication settings can be changed.
Built-in LAN / Select the Ethernet connection port on the V9 series from the internal LAN communication unit.
The icon changes each time it is clicked.
PLC Setting / Switch between PLC settings and other settings.
The icon changes each time it is clicked.
Make MONITOUCH settings on the V9 series.
3.
Contents
1.4 Hardware Settings
1-43