Fuji Electric Monitouch V9 Series Connection Manual page 259

9-66 9. MITSUBISHI ELECTRIC
Available Device Memory
The available setting range of device memory varies depending on the model. Be sure to set within the range available for the
model to be used. Use [TYPE] when assigning indirect device memory for macro programs.
F01 (status display/fraction display)
05 (parameter)
F05 (parameter/fraction display)
12 (External I/O signals)
33 (Alarm history)
02 (Current alarm)
F35 (Status display at alarm occurrence/fraction display)
42 (Other commands)
81 (Status display data erasure)
82 (Alarm history erasure)
8B (Operation mode selection)
90 (I/O device prohibition/cancel)
92 (Input device ON/OFF)
A0 (Test operation mode data)
Set the target device memory on the [Device Input] dialog.
 RAM: Stored in RAM
 EEPROM: Stored in RAM + EEPROM
Indirect Device Memory Designation
 Address No. 0 to 65535
n+0
n+1
n+2
n+3
* Expansion code
15
0
Expansion bits
0: 0 to 15 bits
1: 16 to 31 bits
PLC_CTL
Macro command "PLC_CTL F0 F1 F2"
Contents
Software version
Device Memory
15 8 7
Models
Address No.
Expansion code *
00
0 0 0 0 0
F0
n
n + 1
1 - 8
(PLC1 - 8)
n + 2
n+3 to n+10
TYPE
00H Real number, read only
01H Double-word
02H Real number
03H Double-word, partially read only
04H Double-word, read only
05H Read only
06H Real number, read only
0DH Double-word, read only
0EH Write only
0FH Write only
10H Write only
11H Write only
12H Double-word, write only
13H Double-word, write only
0
Device Type
Bit designation
Station number
8
0: RAM
1: RAM+EEPROM
F1 (= $u n)
Station number
Command: 0002H
Data No. 0070H
Software version
Remarks
Return data: Data stored from controller to V series
F2
3