Fuji Electric Monitouch V9 Series Connection Manual page 296

13.1.2 SYSMAC CV
Communication Setting
Editor
Communication setting
Connection Mode
Signal Level
Baud Rate
Data Length
Stop Bit
Parity
Target Port No.
Transmission Mode
Transmission mode 2
When the transmission mode 2 (BCD with signs) is selected, data in the PLC device memory can be displayed on MONITOUCH
as data with signs.
When higher 4 bits in the device memory indicates [F] or [A], it is treated as negative.
[F]: Regards higher 4 bits as [0].
[A]: Regards higher 4 bits as [1].
 Displayable range 1 word:
Example:
PLC Device Memory
00000000 to 99999999
F0000001 to F9999999
A0000000 to A9999999
 Setting procedure: Num. Display [Input Type: BCD]
PLC
CPU Unit
Communication selector switch
Communication Selector Switch
Item
1 : 1 / 1 : n / Multi-link2 / Multi-link2 (Ethernet) /
1999 to +9999
2 words: 19999999 to +99999999
0000 to 9999
F001 to F999
A000 to A999
[Display Type: DEC] (w/ sign , w/ sign +)
RS-232
RS-422
Setting
1 : n Multi-link2 (Ethernet)
RS-232C / RS-422
4800 / 9600 / 19200 bps
7 / 8 bits
1 / 2 bits
None / Odd / Even
0 to 31
Transmission Mode 1 /
Transmission Mode 2
Indication on the V Series
0 to 9999
1 to 999
1000 to 1999
0 to 99999999
1 to 9999999
10000000 to 19999999
Upper: RS-232C
Lower: RS-422
13.1 PLC Connection
(Underlined setting: default)
Remarks
Transmission Mode 1: BCD without signs
Transmission Mode 2: BCD with signs
Setting
13-9