Micro Smart - Fuji Electric Monitouch V9 Series Connection Manual

3.1.2

MICRO Smart

Communication Setting
Editor
Communication setting
Item
Connection Mode
Signal Level
Baud Rate
Data Length
Stop Bit
Parity
Target Port No.
PLC
Function setting (communication)
Item
Communication Type
Baud Rate (bps)
Data Bit Length
Parity
Stop Bit Length
Receive Timeout Time
Communication Device No.
Communication Selection Input
Available Device Memory
The available setting range of device memory varies depending on the PLC model. Be sure to set within the range available for
the PLC to be used. Use [TYPE] when assigning indirect device memory for macro programs.
D (data register)
I (input)
Q (output)
M (internal relay)
R (shift register)
TS (timer/set value)
TN (timer/enumerated value)
T (timer/contact)
CS (counter/set value)
CN (counter/enumerated value)
C (counter/contact)
*1 The assigned device memory is expressed as shown on the right when editing the
screen.
The addresses are expressed in "bytes". For word designation, specify an
even-numbered address.
1 : 1 / 1 : n / Multi-link2 / Multi-link2 (Ethernet) /
1 : n Multi-link2 (Ethernet)
RS-232C / RS-422/485
4800 / 9600 / 19200 bps
None / Odd / Even
Maintenance communication
4800 / 9600 / 19200 bps
None / Odd / Even
Make settings in accordance with the network
Device Memory
Setting
7 / 8 bits
1 / 2 bits
0 to 31
Setting
7 / 8 bits
1 / 2 bits
environment.
0
X0000
TYPE
00H
01H *1
02H *1
03H *1
04H
05H
06H
07H Read only
08H
09H
0AH Read only
3.1 PLC Connection
Remarks
(Underlined setting: default)
Remarks
Remarks
Example: M2000
Last one digit: 0 to 7 (octal)
Other digits: 0 to 9 (decimal)
3-3