Fuji Electric Monitouch V9 Series Connection Manual page 311

13-24 13. OMRON
PLC
Communication setting
Make the following settings on CX Programmer. For more information, refer to the PLC manual issued by the manufacturer.
Parameter setting
Item
IP Address
Subnet Mask
IP Address Conversion
IP Address Table
FINS/UDP Port
Rotary switch
Switch
NODE No.
CX-Integrator
Set the PLC routing table on "CX-Integrator". Two types of routing tables are available: local network table and relay network
table.
An error will occur unless these settings are made correctly. For more information, refer to the PLC manual issued by the
manufacturer.
 Local network table
Set the unit number and network number of the communication unit.
 Relay network table
Set the network number of the access target (final network No.) and the first relay point (relay network No., relay node
No.).
Available Device Memory
The available device memory is the same as the one described in "13.1.5 SYSMAC CS1/CJ1 (Ethernet)".
IP address of the PLC
Subnet mask of the PLC
IP address table
IP address and node number of the PLC
IP address and node number of the V9
Default (9600)
Set the node number of the Ethernet unit or Controller Link unit.
Setting
Setting