Glofa Gm Series (Ethernet Udp/Ip) - Fuji Electric Monitouch V9 Series Connection Manual

8.1.6

GLOFA GM Series (Ethernet UDP/IP)

Communication Setting
Editor
Make the following settings on the editor. For more information, see "1.3.2 Ethernet Communication".
 IP address for the V9 unit
- When specified on the screen program:
[System Setting]  [Hardware Setting]  [Local Port IP Address]
- When specified on the V9 unit:
Local mode  [LAN Setting]
 Port number for the V9 unit (for communication with PLC)
[System Setting]  [Hardware Setting]  [PLC Properties]  [Communication Setting]
 IP address and port number (No. 2005) of the PLC
Register on the [PLC Table] in [System Setting]  [Hardware Setting]  [PLC Properties]  [Target Settings].
PLC
Set the IP address using "Enet Editor".
The port number is fixed to "2005".
For more information, refer to the PLC manual issued by the manufacturer.
Calendar
This model is not equipped with the calendar function. Use the built-in clock of the V series.
Available Device Memory
The contents of "Available Device Memory" are the same as those described in "8.1.3 GLOFA CNET".
8.1 PLC Connection 8-9