13-18
13. OMRON
13.1.5 SYSMAC CS1/CJ1 (Ethernet)
Communication Setting
Editor
Make the following settings on the editor. For more information, see "1.3.2 Ethernet Communication".
IP address for the V9 unit
- When specified on the screen program:
[System Setting] [Hardware Setting] [Local Port IP Address]
- When specified on the V9 unit:
Local mode [LAN Setting]
Port number for the V9 unit (for communication with PLC) and node address
[System Setting] [Hardware Setting] [PLC Properties] [Communication Setting]
IP address and port number of the PLC
Register on the [PLC Table] in [System Setting] [Hardware Setting] [PLC Properties] [Target Settings].
Set the node number of the V9.
Set the same number as the V9 node
number specified for [IP Address
Table] on the PLC.
Set the same number as the one
specified for [FINS/UDP Port] on the
PLC.
Valid only for 1 : 1 connection
Select the PLC for connection from those
registered on the PLC table.
PLC table No. = PLC node address
Set the IP address, port number and whether
or not to use the KeepAlive function to the
same number as the PLC node address.