Xgt/Xgk Series Cpu - Fuji Electric Monitouch V9 Series Connection Manual

8-12 8. LS
8.1.8

XGT/XGK Series CPU

Communication Setting
Editor
Communication setting
Item
Connection Mode
Signal Level
Baud Rate
Data Length
Stop Bit
Parity
PLC
No particular setting is necessary on the PLC.
The following settings are fixed; baud rate: 115200 bps, data length: 8 bits, without parity, and stop bit: 1 bit.
Available Device Memory
The contents of "Available Device Memory" are the same as those described in "8.1.7 XGT/XGK Series CNET".
8.1.9 XGT / XGK Series (Ethernet)
Communication Setting
Editor
Make the following settings on the editor. For more information, see "1.3.2 Ethernet Communication".
 IP address for the V9 unit
- When specified on the screen program:
[System Setting]  [Hardware Setting]  [Local Port IP Address]
- When specified on the V9 unit:
Local mode  [LAN Setting]
 Port number for the V9 unit (for communication with PLC)
[System Setting]  [Hardware Setting]  [PLC Properties]  [Communication Setting]
 IP address and port number (No. 2004 for TCP/IP or No. 2005 for UDP/IP) of the PLC
Register on the [PLC Table] in [System Setting]  [Hardware Setting]  [PLC Properties]  [Target Settings].
PLC
Go to [Standard Settings] in XG-PD and set the IP address.
The port numbers are 2004 for TCP/IP and 2005 for UDP/IP (both fixed).
For more information, refer to the PLC manual issued by the manufacturer.
Calendar
Although this model is equipped with the calendar function, the V series cannot read and write to the calendar. Use the
built-in clock of the V series.
Available Device Memory
The contents of "Available Device Memory" are the same as those described in "8.1.7 XGT/XGK Series CNET".
Setting
1 : 1 / Multi-link2 / Multi-link2 (Ethernet)
RS-232C
115200 bps
8 bits
1 bit
None
(Underlined setting: default)
Remarks