Toyopuc (Ethernet Pc10 Mode) - Fuji Electric Monitouch V9 Series Connection Manual

4.1.3

TOYOPUC (Ethernet PC10 Mode)

Communication Setting
Editor
Make the following settings on the editor. For more information, see "1.3.2 Ethernet Communication".
 IP address for the V9 unit
- When specified on the screen program:
[System Setting]  [Hardware Setting]  [Local Port IP Address]
- When specified on the V9 unit:
Local mode  [LAN Setting]
 Port number for the V9 unit (for communication with PLC)
[System Setting]  [Hardware Setting]  [PLC Properties]  [Communication Setting]
 IP address and port number of the PLC
Register on the [PLC Table] in [System Setting]  [Hardware Setting]  [PLC Properties]  [Target Settings].
PLC
Settings are possible either in the software "PCwin" or ladder programs. For settings using ladder programs, refer to the PLC
manual issued by the manufacturer.
Communication Setting Switches L1 and L2
SW
L1 Auto
L2 Auto
L1 SEL.
L3 T-ON
PCwin
Link parameter setting
Item
Rack No.
Slot No.
Link Module Name
Ethernet setting
Item
Local Node IP Address
Setting 1/Setting 2/
Setting 3/Setting 4/
Connection 1 - 32 *
Initialization
* When multiple V9 units are connected, make the settings for each unit. A maximum of 32 units can be connected at one time.
Other node table setting
Item
Setting 1/Setting 2
Table 1 to 32
Other Node IP Address
Other Node Port No.
No. Item
1 L3 SN-IF use setting
2 L1 communication setting
10M
3 L2 baud rate switching
10M
DM
4 L1 baud rate switching
T-OFF
Built-in
L1 / L2
Ethernet (32 ports)
Set the IP address of the PLC.
Setting 1: Connection 1 to 8
Setting 2: Connection 9 to 16
Setting 3: Connection 17 to 24
Setting 4: Connection 25 to 32
Protocol: UDP
Local Node Port No.: Port number of the PLC
Other Node Table No.: Table number for which the V9 is registered
Initialize using the link parameter
Setting 1: Table 1 to 16
Setting 2: Table 17 to 32
Check each box for "Use".
Set the IP address of the V9.
Set the port number of the V9.
4.1 PLC Connection
OFF: Not used (T-OFF)
ON: Link parameter (L1 SEL.)
ON: Auto negotiation (L2 Auto)
OFF: 10M bps (10M)
ON: Auto negotiation (L1 Auto)
OFF: 10M bps (10M)
Setting
Setting
Setting
Setting
4-7