Dip Switch - Fuji Electric Monitouch V9 Series Connection Manual

THU-2755 / THU-5139 / THU-2927
Rotary switch
Switch
SW1
SW2
SW3

DIP switch

Switch No.
SW4-4
SW4-3
SW4-2
SW4-1
Available Device Memory
The available setting range of device memory varies depending on the PLC model. Be sure to set within the range available for
the PLC to be used. Use [TYPE] when assigning indirect device memory for macro programs.
D (data register)
R (link register)
B (file register)
N (current value register)
X (input)
Y (output)
M (internal relay)
K (keep relay)
L (link relay)
T (timer/contact)
C (counter/contact)
U (extensional data register)
H (extensional set value register)
EN (extensional current value register)
EX (extensional input)
EY (extensional output)
EM (extensional internal relay)
EK (extensional keep relay)
EL (extensional link relay)
ET (extensional timer/contact)
EC (extensional counter/contact)
V (special register)
Setting
0 Station 0
Set the number from 00 to 37 in octal notation. SW1 denotes the higher-order digit, and SW2
0
denotes the lower-order digit.
Baud rate
1
1: 19200, 2: 9600, 3: 4800
Setting
ON Data length: 7 bits
OFF Stop bit: 2 bits
ON Module selection: computer link
OFF 2-wire system or not used
Device Memory
Remarks
Contents
TYPE
00H PRG No. when [Data Area Division] is selected
01H PRG No. when [Data Area Division] is selected
02H PRG No. when [Data Area Division] is selected
03H PRG No. when [Data Area Division] is selected
04H WX as word device
05H WY as word device
06H WM as word device, PRG No. when [Data Area Division] is selected
07H WK as word device, PRG No. when [Data Area Division] is selected
08H WL as word device, PRG No. when [Data Area Division] is selected
09H WT as word device, PRG No. when [Data Area Division] is selected
0AH WC as word device, PRG No. when [Data Area Division] is selected
0BH
0CH
0DH
0EH WEX as word device
0FH WEY as word device
10H WEM as word device
11H WEK as word device
12H WEL as word device
13H WET as word device
14H WEC as word device
15H WV as word device
4.1 PLC Connection
Remarks
4-3