Fuji Electric Monitouch V9 Series Connection Manual page 64

Printer properties
Item
Printer Control Device
Printer Info Output Device
Always Output Status Bit
Orientation
Hard Copy
Reversed Image
Data Sheet Data Sheet Setting
Use PictBridge only on USB-B port.
When this setting is enabled and the bit is set to ON (0  1), screen images and data sheets
can be printed out.
MSB
15 14 13 12 11 10 09 08 07 06 05 04 03 02 01 00
0 0 0 0 0 0
When this setting is enabled, the status of the printer is stored in the specified address.
MSB
15 14 13 12 11 10 09 08 07 06 05 04 03 02 01 00
0 0 0 0 0 0
0: End (standby)
1: Transferring print data
The V9 series outputs [0  1] when starting to transfer data upon receiving a print command,
and outputs [1  0] upon finishing transfer. However, these signals may not be output if the
print data is small.
Select [Yes] to output a signal regardless of the data size.
The output area is as follows:
 Bit 1 of the device memory for printer information output
 Bit 0 of internal device memory $s16
$s16
MSB
15 14 13 12 11 10 09 08 07 06 05 04 03 02 01 00
0 0 0 0 0
Specify the printing orientation of the screen on paper.
In vertical output, the screen is rotated 90 clockwise with respect to the printing paper and
printed out.
 Printing examples of hard copies:
Horizontal
A
Reversed: Screens are printed with black and white inverted.
Normal: Screens are printed as they are displayed on MONITOUCH.
Make settings for printing data sheets. For more information, refer to the V9 Series Reference
Manual.
Make this setting when using a PictBridge-compatible printer.
Select [Yes] when starting up the USB-B port as the connection port for a PictBridge printer in
the RUN mode.
When transferring screen programs via the USB-B port, switch to Local mode.
1.4 Hardware Settings
Contents
0 0 0 0 0 0 0
0  1: Screen image output
0  1: Data sheet output
0 0 0 0 0 0 0
0: Not busy status
1: Busy status
0 0 0 0 0 0 0
0: End (standby)
1: Transferring print data
Vertical
1-53
LSB
0
LSB
0
LSB
0 0