Fuji Electric Monitouch V9 Series Connection Manual page 244

Available Device Memory
The available setting range of device memory varies depending on the PLC model. Be sure to set within the range available for
the PLC to be used. Use [TYPE] when assigning indirect device memory for macro programs.
D (data register)
W (link register)
R (file register)
TN (timer/current value)
CN (counter/current value)
M (internal relay)
L (latch relay)
B (link relay)
X (input)
Y (output)
TS (timer/contact)
TC (timer/coil)
CS (counter/contact)
CC (counter/coil)
SD (special register)
SM (special relay)
SB (special link relay)
SW (special link register)
ZR (file register/for continuous access)
F (annunciator)
SS (totalizing timer/contact)
SC (totalizing timer/coil)
SN (totalizing timer/current value)
Z (index register)
# (motion register)
Specifying the access CPU
In addition to the device type and address, an access CPU must be specified. The assigned device memory is expressed as
shown below when editing the screen.
Example: 1 : D00000
* The multi CPU unit numbers are assigned as shown below:
- For Q170MCPU
Management CPU: Motion CPU
Multi CPU 1:
Multi CPU 2:
- For Q172DCPU-S1/Q173DCPU-S1
Management CPU: Motion CPU
Multi CPU 1 to 4:
Indirect Device Memory Designation
 For the address number of 0 to 65535:
15
n + 0
n + 1
n + 2
Expansion code
n + 3
* Specify the access CPU number in the expansion code.
Management CPU: 0
Device Memory
Address number
Device type
Access CPU No. 0: Management CPU
No. 1: Multi CPU 1
No. 2: Multi CPU 2
No. 3: Multi CPU 3
No. 4: Multi CPU 4
Sequencer CPU
Motion CPU
Determined according to the slot position of the CPU
8 7
Model Device type
Address No.
* Bit designation
00 Station number
Multi CPU: 1 or 4
TYPE
00H
01H
02H Available only for the sequencer CPU
03H Available only for the sequencer CPU
04H Available only for the sequencer CPU
06H
07H Available only for the sequencer CPU
08H
09H
0AH
0BH Available only for the sequencer CPU
0CH Available only for the sequencer CPU
0DH Available only for the sequencer CPU
0EH Available only for the sequencer CPU
10H
11H
12H Available only for the sequencer CPU
13H Available only for the sequencer CPU
14H Available only for the sequencer CPU
15H
16H Available only for the sequencer CPU
17H Available only for the sequencer CPU
18H Available only for the sequencer CPU
19H Available only for the sequencer CPU
2AH Available only for the motion CPU
 For the address number of 65536 or greater:
0 15
n + 0
n + 1
n + 2
n + 3
Expansion code
n + 4
9.1 PLC Connection
Remarks
8 7
Model Device type
Lower address No.
Higher address No.
*
Bit designation
00 Station number
9-51
0