Fuji Electric Monitouch V9 Series Connection Manual page 364

15.1.1 FP Series (RS232C/422)
Communication Setting
Editor
Communication setting
Item
Connection Mode
Signal Level
Baud Rate
Data Length
Stop Bit
Parity
Target Port No.
Header
Monitor Registration
PLC
Be sure to match the settings to those made under [Communication Setting] of the editor.
FP-X
Tool port setting
System Register
410
412
413
415
*1 System register setting is enabled in the RUN mode.
COM port setting
System Register
COM1 COM2
410
412
413
415
*1 System register setting is enabled in the RUN mode.
*2 For AFPX COM3, set the switch attached to the back of the cassette as well.
SW1 to 3: ON (RS-485), SW4: ON (terminator ON)
*3 Some restrictions may apply to the communication cassette when the USB port is used on the CPU. For more information, refer to the
PLC manual issued by the manufacturer.
1 : 1 / 1 : n / Multi-link / Multi-link2 /
Multi-link2 (Ethernet) / 1 : n Multi-link2 (Ethernet)
RS-232C / RS-422/485
4800 / 9600 / 19200 / 38400 /57600 / 115k bps
None / Odd / Even
% (Header) / < (Extension Header)
Unchecked / Checked
*1
Unit No.
Communication Mode
Data Length
Parity
Stop Bit
Baud Rate
*1
411 Unit No.
Operation Mode
Data Length
414 Parity
Stop Bit
Baud Rate
Setting
7 / 8 bits
1 / 2 bits
0 to 31
Models on which "< (Extension header)" is available:
FP2, FP2SH, FP, FP-X, FP0R
One V9 unit can be registered as a monitor for one
PLC. When multi-link connection (n : 1) is selected, do
not check this box for multiple V9 units.
Contents
1 to 99
Computer link
7 / 8 bits
None / Odd / Even
1 / 2 bits
4800 / 9600 / 19200 / 38400 /57600 / 115k bps
Contents
1 to 99
Computer link
7 / 8 bits
None / Odd / Even
1 / 2 bits
4800 / 9600 / 19200 / 38400 /57600 / 115k bps
15.1 PLC Connection
(Underlined setting: default)
Remarks
(Underlined setting: default)
(Underlined setting: default)
*2
15-3