Rex-F400/F700/F900 (Standard Protocol) - Fuji Electric Monitouch V9 Series Connection Manual

16.1.5 REX-F400/F700/F900 (Standard Protocol)

Communication Setting
Editor
Communication setting
Item
Connection Mode
Signal Level
Baud Rate
Data Length
Stop Bit
Parity
Target Port No.
REX-F400/F700/F900
Parameter group (PG) 24
The communication parameters can be set using keys attached to the temperature controller. Be sure to match the settings to
those made under [Communication Setting] of the editor.
Indication
Communication data bit
bIT
configuration
Add Device address
bPS Baud rate
InT Interval time setting
* The "COMP" mode must be selected for communication with the V9 series.
Press the [MODE] key to display "Computer Mode Change", and change the mode from [LOC] to [COMP] by pressing
the [ ] key.
Available Device Memory
The available setting range of device memory varies depending on the controller model. Be sure to set within the range
available for the controller to be used. Use [TYPE] when assigning indirect device memory for macro programs.
GRP0
GRP1
Setting
1 : 1 / 1 : n / Multi-link2 /
Multi-link2 (Ethernet) /
1 : n Multi-link2 (Ethernet)
RS-232C / RS-422/485
4800 / 9600 / 19200 bps
7/ 8 bits
1 / 2 bits
None / Odd / Even
0 to 31
Item
0: 8 bits / 1 bit / none
1: 8 bits / 2 bits / none
2: 8 bits / 1 bit / even
3: 8 bits / 2 bits / even
4: 8 bits / 1 bit / odd
5: 8 bits / 2 bits / odd
6: 7 bits / 1 bit / none
7: 7 bits / 2 bits / none
8: 7 bits / 1 bits / even
9: 7 bits / 2 bits / even
10: 7 bits / 1 bit / odd
11: 7 bits / 2 bits / odd
0 to 31
2: 4800 bps
3: 9600 bps
4: 19200 bps
0 to 250 msec
Device Memory
16.1 Temperature Controller/Servo/Inverter Connection
Setting
TYPE
00H Read only
01H
16-7
(Underlined setting: default)
Remarks
(Underlined setting: default)
Remarks
Remarks