Fuji Electric Monitouch V9 Series Connection Manual page 158

SG-8
Universal Communication Port
System parameter setting
Set the station number using the system parameter setting of the programmer. For more information, refer to the PLC manual
issued by the manufacturer.
Station number
Data type
The following settings are fixed; data length: 8 bits, parity: odd, and stop bit: 1 bit.
DIP switch
The DIP switch provided at the rear of the CPU is used to make the following settings.
Switch
Host Link Module (G-01DM)
Online/offline selector switch
Selector Switch
ONLINE
OFFLINE
DIP switch (SW1)
SW1
ON
Item
Item
No. 1 Signal level
Station number
No. 2
setting
No. 3
Baud rate
No. 4
Online
Item
No. 1
No. 2
No. 3
Station number
No. 4
setting
No. 5
No. 6
No. 7
No. 8 P-P setting
Master/slave
No. 9
setting
Setting
1 to 90
HEX
Setting
OFF: RS-422
ON: RS-232C
OFF: According to the system parameter setting
ON: Fixed to 01
SW3
9600 bps ON
19200 bps ON
Setting
Setting
1 to 90
1 2 3 4
1 ON OFF OFF OFF
2 OFF ON OFF OFF
3 ON ON OFF OFF
: : : : :
88 OFF OFF OFF ON
89 ON OFF OFF ON
90 OFF ON OFF ON
OFF
OFF: Slave
7.1 PLC Connection
(Underlined setting: default)
Remarks
Valid only when DIP switch No. 2 is set to OFF
(Underlined setting: default)
SW4
OFF
ON
(Underlined setting: default)
5 6 7
For more information on any
OFF OFF OFF
station number settings
OFF OFF OFF
other than those given on
OFF OFF OFF
the left, refer to the PLC
: : :
manual issued by the
ON OFF ON
manufacturer.
ON OFF ON
ON OFF ON
7-7
Remarks
Remarks