Fuji Electric Monitouch V9 Series Connection Manual page 159

7-8 7. KOYO ELECTRONICS
DIP switch (SW2)
SW2
ON
Short plug 1
Short plug 1 is used to short-circuit the FG (frame ground) and 0-V power for the communication system.
G
FG
Short plug 2
Short plug 2 is used to switch the signal level of the CH2 port.
RS-232C
ENABLE
PZ3
Universal Communication Port
Settings are the same as those described in "SZ-4" (page 7-6).
Available Device Memory
The available setting range of device memory varies depending on the PLC model. Be sure to set within the range available for
the PLC to be used. Use [TYPE] when assigning indirect device memory for macro programs.
R (data register)
I (input)
Q (output)
M (internal relay)
S (stage)
GI (link input)
GQ (link output)
T (timer/contact)
C (counter/contact)
Item
No. 1
No. 2 Baud rate
No. 3
No. 4 Parity
No. 5 Self diagnosis
Turnaround
No. 6
delay
No. 7 Response delay
No. 8 time
ASCII/HEX
No. 9
selection
Plug
G side: Not short-circuited
FG side: Short-circuited
Plug
RS-232C
RS-232C ENABLE: RS-232C
DISABLE
RS-232C DISABLE: RS-422
Device Memory
Setting
SW1
4800 bps ON
9600 bps OFF
19200 bps ON
OFF: No parity
ON: Odd parity
OFF: Not provided
OFF: Not provided
OFF: 0 ms
OFF: HEX
Setting
Setting
TYPE
00H
01H
02H
03H
04H
05H
06H
07H
08H
(Underlined setting: default)
SW2 SW3
OFF ON
ON ON
ON ON
Remarks
Remarks
Remarks
Remarks