Fuji Electric Monitouch V9 Series Connection Manual page 262

9.2.5 MR-J3-*T
Communication Setting
Editor
Communication setting
Item
Connection Mode
Signal Level
Baud Rate
Data Length
Stop Bit
Parity
Target Port No.
Servo amplifier
Extension setting parameters
To make the parameter setting valid, the power supply is turned on again.
Parameter
Symbol
No.
PC20 SNO
PC21 SOP
Available Device Memory
The available setting range of device memory varies depending on the model. Be sure to set within the range available for the
model to be used. Use [TYPE] when assigning indirect device memory for macro programs.
F01 (status display)
12 (external I/O signals)
33 (alarm history)
02 (current alarm)
F35 (status display at alarm occurrence)
42 (other commands)
81 (status display data erasure)
82 (alarm history erasure)
8B (operation mode selection)
90 (I/O device prohibition/cancel)
92 (input device ON/OFF)
A0 (test operation mode data)
S01 (status display name and unit)
04 (parameters)
05A (basic setting parameters)
05B (gain/filter parameters)
05C (extension setting parameters)
05D (I/O setting parameters)
F05A (basic setting parameters)
F05B (gain/filter parameters)
F05C (extension setting parameters)
F05D (I/O setting parameters)
Setting
1 : 1 / 1 : n / Multi-link2 /
Multi-link2 (Ethernet) /
1 : n Multi-link2 (Ethernet)
RS-232C / RS-422/485
9600 / 19200 / 38400 / 57600 / 115K bps
8 bits (fixed)
1 bit (fixed)
Even (fixed)
0 to 31
Item
Station number setting
Communication function selection
Device Memory
9.2 Temperature Controller/Servo/Inverter Connection
0 to 31
0 0
Response delay time
0: Invalid
1: Valid
TYPE
00H Real number, read only
03H Double-word, partially read only
04H Double-word, read only
05H Read only
06H Real number, read only
0DH Double-word, read only
0EH Write only
0FH Write only
10H
11H Write only
12H Double-word, write only
13H Double-word, write only
14H Read only
15H
16H Double-word
17H Double-word
18H Double-word
19H Double-word
1AH Real number
1BH Real number
1CH Real number
1DH Real number
(Underlined setting: default)
Remarks
(Underlined setting: default)
Setting Example
Baud rate
0: 9600 bps
1: 19200 bps
2: 38400 bps
3: 57600 bps
4: 115200 bps
Remarks
9-69