Srv (Modbus Rtu) - Fuji Electric Monitouch V9 Series Connection Manual

16-4 16. RKC

16.1.2 SRV (MODBUS RTU)

Communication Setting
Editor
Communication setting
Item
Connection Mode
Signal Level
Baud Rate
Data Length
Stop Bit
Parity
Target Port No.
SRV
Address setting switch
Switch
2 3
1
4
0 5
9 6
8 7
2 3
1 4
5
0
9 6
8 7
DIP switch setting
Switch
1
2
3
4
5
6
7
8
* Communication time settings (send changeover time/data interval delay time) can be made using the switches 4, 5, and 6. For more
information, refer to the communication instruction manual for SRV.
Available Device Memory
The available setting range of device memory varies depending on the controller model. Be sure to set within the range
available for the controller to be used. Use [TYPE] when assigning indirect device memory for macro programs.
Device Memory
---
Setting
1 : 1 / 1 : n / Multi-link2 /
Multi-link2 (Ethernet) /
1 : n Multi-link2 (Ethernet)
RS-232C / RS-422/485
9600 / 19200 / 38400 bps
None / Odd / Even
1 to 31
Setting
00 to 30
Setting Contents
ON
Baud rate: 38400 bps
ON
ON
Data bit configuration
OFF
8 bits / 1 bit / without parity
OFF
ON Protocol: Modbus
OFF -
OFF -
TYPE
00H
8 bits
1 bit
Higher-order digit setting ( 10)
Lower-order digit setting ( 1)
The number that is one greater than the set value is the address.
ON, OFF: 9600 bps
OFF, ON: 19200 bps
ON, OFF, ON: 8 bits / 1 bit / even
ON, ON, ON: 8 bits / 1 bit / odd
(Underlined setting: default)
Remarks
Remarks
Remarks
Remarks