Fuji Electric Monitouch V9 Series Connection Manual page 338

 Synchronized writing
Writing starts when the control device memory (command bit) is set (ON). When writing has been finished, the control
device memory (acknowledge bit) is set (ON).
Writing Cycle
Control Device
Guarantee synchronism of the
data
Infinite retrials
*1 Set the device memory address of the same station number and channel in the device memory map.
*2 This setting is invalid when the macro command "TBL_WRITE" is executed.
ID Controller
V600-CA1A/V600-CA2A
DIP Switch
DIP switch 1
1 2 3 4 5
Item
The data is written into the device memory addresses registered in the device memory map when the
control device memory (command bit) is set (ON).
When writing of data finishes, the control device memory (acknowledge bit) is set (ON) regardless of
the result of the writing status.
Enter a device memory address as the trigger for synchronized writing.
The specified address is used for the device memory map Nos. 0 to 31. Four words are occupied. For
more information, see the V9 Series Reference Manual.
When the box is checked, retry is made until the first data is correctly written into the address
registered in the device memory map.
Check the status/error codes at $Pn 356 to 451 to confirm whether or not writing of subsequent data
has been completed successfully.
When the box is checked, retry is made until all data is correctly written into the addresses registered
in the device memory map.
Status/error codes are stored in $Pn 356 to 451.
Baud rate setting
SW1
SW1
SW2
ON
SW3
ON
ON
Communication format
SW4
OFF
6 7 8
OFF
SW4
OFF
SW5
OFF
SW6
ON
ON
ON
ON
SW7
Always OFF
SW8
13.2 Temperature Controller/Servo/Inverter Connection
Contents
*1
*1
SW2 SW3 Baud Rate
OFF ON 4800
ON OFF 9600
ON ON 19200
SW5 SW6 Data Length
OFF OFF
OFF ON
7
ON OFF
ON ON
OFF OFF
OFF ON
8
ON OFF
ON ON
Setting
Stop Bit Parity
Even
2
Odd
Even
1
Odd
2
None
1 Even
Odd
13-51
(Default: OFF (all))