Q170Mcpu (Multi Cpu) - Fuji Electric Monitouch V9 Series Connection Manual

9.1.27 Q170MCPU (Multi CPU)

Editor
Communication setting
Item
Connection Mode
Signal Level
Baud Rate
Data Length
Stop Bit
Parity
PLC
When using the PLC for the first time, the operating system must be installed. For more information, refer to the PLC manual
issued by the manufacturer.
No communication setting is required.
Available Device Memory
The available setting range of device memory varies depending on the PLC model. Be sure to set within the range available for
the PLC to be used. Use [TYPE] when assigning indirect device memory for macro programs.
D (data register)
W (link register)
R (file register)
TN (timer/current value)
CN (counter/current value)
SPU (special unit buffer memory)
M (internal relay)
L (latch relay)
B (link relay)
X (input)
Y (output)
TS (timer/contact)
TC (timer/coil)
CS (counter/contact)
CC (counter/coil)
SD (special register)
SM (special relay)
SB (special link relay)
SW (special link register)
ZR (file register/for continuous access)
F (annunciator)
SS (totalizing timer/contact)
SC (totalizing timer/coil)
SN (totalizing timer/current value)
Z (index register)
# (motion register)
*1 The unit number is required in addition to the device type and address. To set the device memory address on the editor for the link unit
which has byte-addressable memory, convert the address into word address.
For the unit number, set the decimal number of "XXX" included in the station I/O number "xxx0 H" of the link unit. For more information,
see page 9-16.
1 : 1 / Multi-link2 / Multi-link2 (Ethernet)
9600 / 19200 / 38400 / 57600 / 115K bps
Device Memory
Setting
RS-232C
8 bits
1 bit
Odd
TYPE
00H
01H
02H Available only for the sequencer CPU
03H Available only for the sequencer CPU
04H Available only for the sequencer CPU
05H
Available only for the sequencer CPU
06H
07H Available only for the sequencer CPU
08H
09H
0AH
0BH Available only for the sequencer CPU
0CH Available only for the sequencer CPU
0DH Available only for the sequencer CPU
0EH Available only for the sequencer CPU
10H
11H
12H Available only for the sequencer CPU
13H Available only for the sequencer CPU
14H Available only for the sequencer CPU
15H
16H Available only for the sequencer CPU
17H Available only for the sequencer CPU
18H Available only for the sequencer CPU
19H Available only for the sequencer CPU
1AH Available only for the motion CPU
9.1 PLC Connection
(Underlined setting: default)
Remarks
Remarks
*1
9-47