Fuji Electric Monitouch V9 Series Connection Manual page 345

13-58 13. OMRON
Available Device Memory
The available setting range of device memory varies depending on the model. Be sure to set within the range available for the
model to be used. Use [TYPE] when assigning indirect device memory for macro programs.
C0 Variable area (instantaneous value)
C2 Variable area (maximum value)
C3 Variable area (minimum value)
C000 Parameter area
Indirect Device Memory Designation
15
n + 0 Model (91 to 98)
n + 1
n + 2 Expansion code
n + 3
For bit designation, an expansion code setting is required.
00H: when designating bit 0 to 15
01H: when designating bit 16 to 31
PLC_CTL
Macro command "PLC_CTL F0 F1 F2"
Contents
Status read out
Operation instructions
*1 8000 (HEX): broadcasting
Device Memory
8 7
Device type
Address No.
Bit designation
00 Station number
F0
1 - 8
(PLC1 - 8)
1 - 8
(PLC1 - 8)
TYPE
00H Double-word, read only
02H Double-word, read only
03H Double-word, read only
04H Double-word
0
F1 (= $u n)
n Station number
n + 1 Command: 06H
n + 2 Operation status
n
Station number
n + 1 Command: 30H
0300H: Integral power consumption zero reset
1200H: Maximum of each measurement value reset
n + 2
1300H: Minimum of each measurement value reset
9900H: Software reset
Return data: Data stored from temperature controller to V series
Remarks
*1
F2
2
3