Fuji Electric Monitouch V9 Series Connection Manual page 459

17-8 17. RS Automation
Available Device Memory
The available setting range of device memory varies depending on the PLC model. Be sure to set within the range available for
the PLC to be used. Use [TYPE] when assigning indirect device memory for macro programs.
N (Integer)
X (Input)
Y (Output)
SR (System Registers)
B (Binary)
F (Floating Point)
L (Long)
A (ASCII)
ST (String)
TM (Timer)
CT (Counter)
CR (Control)
Address denotations
The assigned device memory is expressed as shown below when editing the screen.
 Integer, System Registers, Binary, Floating Point, Long, or ASCII addresses
Word designation
A.B
 Input, Output addresses
Word designation
A.B.C
 String, Timer, Counter, or Control addresses
Word designation
A.B.C
Mnemonics can be used to specify Timer, Counter, or Control addresses.
The following shows the representation using mnemonics:
On PLC
TimeBase0
TimeBase1
Done
TimerTiming
Enable
Underflow
Overflow
CountDown
CountUp
Found
Inhibit
- Mnemonics can be used for bit designation on condition that Data Table Sub-Element = 0.
Example: TM9.0.0.8 TM9.0.0.TB0
- Mnemonics can be used for device memory address designation on condition that Data Table Sub-Element = 1 to 4.
Example: TM9.0.1 TM9.0.PRE(L)
For more information on using mnemonics, refer to the PLC manual issued by the manufacturer.
Device Memory
Data Table Element
Data Table Number
Data Table Element
Word Number
Data Table Number
Data Table Sub-Element
Data Table Element
Data Table Number
On V-SFT
TB0
TB1
DN
TT
EN
UF
OF
CD
CU
FD
IH
TYPE
00H
01H
02H
03H
04H
05H Real number. Bit designation is not possible.
06H Double-word
07H
08H STRING type
09H
0AH
0BH
Bit designation
A.B.C
Bit Number
Data Table Element
Data Table Number
Bit designation
A.B.C.D
Bit Number
Data Table Element
Word Number
Data Table Number
Bit designation
A.B.C.D
Bit Number
Data Table Sub-Element
Data Table Element
Data Table Number
Unload
Error
Empty
EnableUnload
Preset(Low)
Preset(High)
Accumulator(Low)
Accumulator(High)
Length
Position
Remarks
On PLC On V-SFT
UL
ER
EM
EU
PRE(L)
PRE(H)
ACC(L)
ACC(H)
LEN
POS