Fb100/Fb400/Fb900 (Modbus Rtu) - Fuji Electric Monitouch V9 Series Connection Manual

16-10 16. RKC

16.1.8 FB100/FB400/FB900 (MODBUS RTU)

Communication Setting
Editor
Communication setting
Item
Connection Mode
Signal Level
Baud Rate
Data Length
Stop Bit
Parity
Target Port No.
FB100/FB400/FB900
The communication parameters can be set using keys attached to the temperature controller. Be sure to match the settings to
those made under [Communication Setting] of the editor.
Communication protocol (engineering mode F60)
Indication
CMP1 Communication 1 protocol
CMP2 Communication 2 protocol
* The temperature controller must be set to "STOP" (control stop) before making settings.
Communication parameter (setup setting mode)
Port
Communication 1
Communication 2
Parameter changes will take effect when the temperature controller is turned off and on again or is switched from "STOP" to
"RUN".
Setting
1 : 1 / 1 : n / Multi-link2 /
Multi-link2 (Ethernet) /
1 : n multi-link2 (Ethernet)
RS-232C / RS-422/485
4800 / 9600 / 19200 / 38400 bps
8 bits
1 / 2 bits
None / Odd / Even
1 to 31
Item
Indication Item
Add1 Device address 1
bPS1 Baud rate 1
bIT1 Data bit configuration 1
InT1 Interval time 1
Add2 Device address 2
bPS2 Baud rate 2
bIT2 Data bit configuration 2
InT2 Interval time 2
Setting
1: MODBUS
1: MODBUS
Setting
1 to 31
4.8: 4800 bps
9.6: 9600 bps
19.2: 19200 bps
38.4: 38400 bps
8n1: 8 bits / none / 1 bit
8n2: 8 bits / none / 2 bits
8E1: 8 bits / even parity / 1 bit
8E2: 8 bits / even parity / 2 bits
8o1: 8 bits / odd parity / 1 bit
8o2: 8 bits / odd parity / 2 bits
0 to 250 msec
1 to 31
4.8: 4800 bps
9.6: 9600 bps
19.2: 19200 bps
38.4: 38400 bps
8n1: 8 bits / none / 1 bit
8n2: 8 bits / none / 2 bits
8E1: 8 bits / even parity / 1 bit
8E2: 8 bits / even parity / 2 bits
8o1: 8 bits / odd parity / 1 bit
8o2: 8 bits / odd parity / 2 bits
0 to 250 msec
(Underlined setting: default)
Remarks
Remarks
(Underlined setting: default)
Remarks
Communication is not performed
when "0" is set.
Communication is not performed
when "0" is set.