Fuji Electric Monitouch V9 Series Connection Manual page 209

9-16 9. MITSUBISHI ELECTRIC
Available Device Memory
The available setting range of device memory varies depending on the PLC model. Be sure to set within the range available for
the PLC to be used. Use [TYPE] when assigning indirect device memory for macro programs.
D (data register)
W (link register)
R (file register)
TN (timer/current value)
CN (counter/current value)
SPU (special unit buffer memory)
M (internal relay)
L (latch relay)
B (link relay)
X (input)
Y (output)
TS (timer/contact)
TC (timer/coil)
CS (counter/contact)
CC (counter/coil)
H (link unit buffer memory)
SD (special register)
SM (special relay)
SB (special link relay)
SW (special link register)
ZR (file register (for continuous access))
F (annunciator)
SS (totalizing timer/contact)
SC (totalizing timer/coil)
SN (totalizing timer/current value)
Z (index register)
*1 The unit number is required in addition to the device type and address. Convert byte address into word address when entering the data
on the editor if the memory device of the link unit is byte address.
For the unit number, set the decimal number of "XXX" included in the station I/O number "xxx0 H" of the link unit.
Example:
When the following settings are made for "Q02HCPU" and connection is established:
With the use of buffer memory of the serial communication unit: Unit No. = "8" (DEC)
With the use of buffer memory of the input unit: Unit No. = "10" (DEC)
With the use of buffer memory of the output unit: Unit No. = "11" (DEC)
Device Memory TYPE
00H
01H
02H
03H
04H
05H *1
06H
07H
08H
09H
0AH
0BH
0CH
0DH
0EH
0FH
10H
11H
12H
13H
14H
15H
16H
17H
18H
19H
Decimal number of "XXX" of the station
I/O No. of "xxx0 H" = Unit No.
Remarks