Selecting A Device To Be Connected - Fuji Electric Monitouch V9 Series Connection Manual

1. Overview
1-44

Selecting a Device to be Connected

Double-click on a PLC icon in the [Hardware Setting] window to display the window shown below.
Item
Connected Device
Maker
Model
Target Port No.
PLC Properties
Click on the PLC icon in [Hardware Setting] to display the window shown below.
Communication
Setting
Double-click
Select the device to connect.
Select the maker of the device.
Select the model of the device to connect. Refer to the respective chapter of each maker and select the
appropriate model.
Select the port to which the device connects to on the V9 series.
Item
Connection Mode
*1
Signal Level
*1
Baud Rate
*1
Data Length
*1
Stop Bit
*1
Parity
*1
Target Port No.
Contents
Select a connection mode.
1 : 1 / 1 : n / Multi-link / Multi-link2 (Ethernet) / 1 : n Multi-link2 (Ethernet)
Available options vary, depending on which device is connected. For details,
see Connection Compatibility List provided at the end of this manual.
Select a signal level.
RS-232C/RS-422/485
Select a baud rate.
4800/9600/19200/38400/57600/76800/115K/187.5K
* Available only when connecting via Siemens S7-200PPI or S7-300/400MPI
and CN1.
Select a data length.
7 / 8 bits
Select a stop bit.
1 / 2 bits
Select an option for parity bit.
None / Odd / Even
Specify a port number of the connected device.
0 to 31 (Modbus RTU: 1 to 255)
Contents
*
bps