Sr-Mini (Standard Protocol) - Fuji Electric Monitouch V9 Series Connection Manual

16-6 16. RKC

16.1.4 SR-Mini (Standard Protocol)

Communication Setting
Editor
Communication setting
Item
Connection Mode
Signal Level
Baud Rate
Data Length
Stop Bit
Parity
Target Port No.
SR-Mini
DIP switch
Switch
1
2
3
4
Unit address setting switch
Switch
0
Available Device Memory
The available setting range of device memory varies depending on the controller model. Be sure to set within the range
available for the controller to be used. Use [TYPE] when assigning indirect device memory for macro programs.
GRP0 (normal: R)
GRP1 (normal: RW)
GRP2 (initial: R)
GRP3 (initial: RW)
* On the signal name reference list, every channel number is designated as
"00".
Manually enter the value obtained by the following procedure: subtract "1"
from the channel to access, and set the hexadecimal number of the
obtained value.
The assigned device memory is expressed as shown on the right when
editing the screen.
Setting
1 : 1 / 1 : n / Multi-link2 /
Multi-link2 (Ethernet) /
1 : n Multi-link2 (Ethernet)
RS-232C / RS-422/485
9600 / 19200 bps
7/ 8 bits
1 / 2 bits
None / Odd / Even
0 to 15
Setting Contents
OFF
8 bits / 1 bit / without parity
OFF
ON
Baud rate: 9600 bps
OFF
Setting
0 to F (= 0 to 15)
Device Memory
OFF, ON: 7 bits, even parity
ON, OFF: 7 bits, odd parity
OFF, ON: 4800 bps
ON, ON: 19200 bps
TYPE
00H Read only
01H
02H Read only
03H
Example: GRP0000001 (measurement value for
(Underlined setting: default)
Remarks
Remarks
(Underlined setting: default)
Remarks
Remarks
CH2 temperature)
Channel number: -1 (HEX)
Address