Fuji Electric Monitouch V9 Series Connection Manual page 154

DIP switch (SW5)
ON
SU-5E/6B
Universal Communication Port
System parameter setting
Set the station number, parity and data type using the system parameter setting of the programmer. For more information,
refer to the PLC manual issued by the manufacturer.
Parity
Station number
Data type
The following settings are fixed; data length: 8 bits, and stop bit: 1 bit.
DIP switch
The DIP switch provided at the rear of the CPU is used to make the following settings.
Switch
ON
Host Link Module (U-01DM)
Settings are the same as those described in "SU-5" (page 7-2).
SW5 Item
No. 1 P-P setting
Master/slave
No. 2
setting
Time-out
No. 3
selection
ASCII/HEX
No. 4
selection
Item
Item
No. 1 Battery mode
Station number
No. 2
setting
No. 3
Baud rate
No. 4
Setting
OFF
OFF: Slave
OFF: Normal operation
OFF: HEX
Setting
Odd / None
1 to 90
HEX
Setting
OFF: Without battery
ON: With battery
OFF: According to the system parameter setting
ON: Fixed to 01
Baud Rate SW3
9600 bps ON
19200 bps ON
7.1 PLC Connection
(Underlined setting: default)
Remarks
(Underlined setting: default)
Remarks
Valid only when DIP switch No. 2 is set to OFF
(Underlined setting: default)
Remarks
SW4
OFF
ON
7-3