Fuji Electric Monitouch V9 Series Connection Manual page 106

Available Device Memory
The available setting range of device memory varies depending on the PLC model. Be sure to set within the range available for
the PLC to be used. Use [TYPE] when assigning indirect device memory for macro programs.
D (data register)
I (input)
Q (output)
M (internal relay)
R (shift register)
TS (timer/set value)
TN (timer/enumerated value)
T (timer/contact)
CS (counter/set value)
CN (counter/enumerated value)
C (counter/contact)
*1 The assigned device memory is expressed as shown on the right when editing the
screen.
The addresses are expressed in "bytes". For word designation, specify an
even-numbered address.
Device Memory TYPE
00H
01H *1
02H *1
03H *1
04H
05H
06H
07H Read only
08H
09H
0AH Read only
3.1 PLC Connection
Remarks
Example: M2000
Last one digit: 0 to 7 (octal)
Other digits: 0 to 9 (decimal)
3-5