Fuji Electric Monitouch V9 Series Connection Manual page 357

Terminating resistance setting switches (TERM.)
TERM.
ARD-KD
MEXE02 (application software)
Setting changes will take effect after turning the power off and back on. If changes are made to any settings, turn the power
off and on again.
Item
Communication timeout*
Parity
Stop bit
Device number setting switch (SW1)
SW1
4
Baud rate setting switch (SW2)
SW2
Function setting switches (SW3)
SW3
1 2 3
Available Device Memory
The available setting range of device memory varies depending on the model. Be sure to set within the range available for the
model to be used. Use [TYPE] when assigning indirect device memory for macro programs.
4 (holding register)
Setting Item
Terminating resistance
Setting
0 to 10000 ms
None / Even / Odd
1 / 2 bits
Setting Item
Device number
Setting Item
Baud rate
No. Setting Item
1 Device number setting
2 Protocol setting
3 Not used
4
4 Terminating resistance
Device Memory
14.1 Temperature Controller / Servo / Inverter Connection
Setting
Both ON: With terminating
resistance
Both OFF: Without
terminating
resistance
0: No check
* If the V series performs no communication for a set timeout
period (other than "0"), an alarm occurs at the stepping motor.
Setting
Device Number
Device No. Setting Switch
(ID)
1 to 15 1 to F
16 to 31 0 to F
Setting
0: 9600 bps
1: 19200 bps
2: 38400 bps
3: 57600 bps
4: 115200 bps
Setting
OFF: 1 to 15
ON: 16 to 31
ON: MODBUS protocol
OFF
ON: With terminating
resistance
OFF: Without terminating
resistance
TYPE
02H
Remarks
Be sure to set both switches to the
same position (ON or OFF).
Turning ON either one only may result
in communication error.
(Underlined setting: default)
Remarks
Remarks
Function Setting
Use this switch together with
Switch
function setting switch (SW3)
(SW3) No. 1
No. 1.
OFF
* Do not use device No. 0.
ON
Remarks
5 to F disabled
Remarks
Use this switch together with the
device number setting switch (SW1).
Remarks
14-3