Fuji Electric Monitouch V9 Series Connection Manual page 306

PLC
Make the following settings on CX Programmer. For more information, refer to the PLC manual issued by the manufacturer.
Parameter setting
Item
IP Address
Subnet Mask
IP Address Conversion
IP Address Table
FINS/UDP Port
Rotary switch
Switch
NODE No.
Available Device Memory
The available setting range of device memory varies depending on the PLC model. Be sure to set within the range available for
the PLC to be used. Use [TYPE] when assigning indirect device memory for macro programs.
DM (data memory)
CH (input/output/internal auxiliary relay)
H (holding relay)
A (auxiliary memory relay)
T (timer/current value)
C (counter/current value)
EMn (extended data memory)
W (internal relay)
TU (timer/contact)
CU (counter/contact)
*1 When using EMn (extended data memory), specify the bank number 0 to C (HEX).
The assigned device memory is expressed as shown on the right when editing the screen.
Indirect Device Memory Designation
 EMn (extended data memory)
Specify the bank number 0 to C (HEX) in the expansion code.
IP address of the PLC
Subnet mask of the PLC
IP address table
IP address and node number of the PLC
IP address and node number of the V9
Default (9600)
Set the FINS node number of the Ethernet unit.
Match the node number to the one registered in the IP address table.
Device Memory
Setting
Setting
TYPE
00H
01H
02H
04H
05H
06H
07H *1
08H
09H Read only
0AH Read only
13.1 PLC Connection
Remarks
Example: EM0 : 30000
Address
Colon
Bank number
13-19