High-Efficiency Ar Series (Modbus Rtu) - Fuji Electric Monitouch V9 Series Connection Manual

14-2 14. Oriental Motor

14.1.1 High-efficiency AR Series (MODBUS RTU)

Communication Setting
Editor
Communication setting
Item
Connection Mode
Signal Level
Baud Rate
Data Length
Stop Bit
Parity
Target Port No.
Stepping Motor
ARD-AD/ARD-CD
MEXE02 (application software)
Setting changes will take effect after turning the power off and back on. If changes are made to any settings, turn the power
off and on again.
Item
Communication timeout
Parity
Stop bit
Baud rate setting switch (SW2)
SW2
Function setting switches (SW4)
SW4
1 2
Device number setting switch (ID)
ID
4
Setting
1 : 1 / 1 : n / Multi-link2 /
Multi-link2 (Ethernet) /
1 : n Multi-link2 (Ethernet)
RS-422/485
9600 / 19200 / 38400 / 57600 / 115K bps
8 bits
1 / 2 bits
None / Odd / Even
0 to 31
Setting
0 to 10000 ms
None / Even / Odd
1 / 2 bits
Setting Item
Baud rate
No. Setting Item
1 Device number setting
Protocol setting
2
Setting Item
Device No.
Device number
1 to 15
16 to 31
0: Broadcast
Remarks
0: No check
* If the V series performs no communication for a set timeout
period (other than "0"), an alarm occurs at the stepping motor.
Setting
0: 9600 bps
1: 19200 bps
2: 38400 bps
3: 57600 bps
4: 115200 bps
Setting
OFF: 1 to 15
ON: 16 to 31
ON: MODBUS protocol
Setting
Function Setting
Device Number
Switch
Setting Switch (ID)
(SW4) No. 1
1 to F OFF
0 to F ON
(Underlined setting: default)
Remarks
(Underlined setting: default)
Remarks
5 to F disabled
Remarks
Use this switch together with the
device number setting switch (ID).
Remarks
Use this switch together
with function setting
switch (SW4) No. 1.
* Do not use device
No. 0.