Fuji Electric Monitouch V9 Series Connection Manual page 118

4-4 4. JTEKT
PRG No. setting
If [Transmission Mode: Data Area Division] is set under [Communication Setting], specify a program number ([PRG No.]) in
addition to device type and address number. The assigned device memory is expressed as shown below when editing the
screen. The PRG No. is invalid for the device memory in the common area.
Indirect Device Memory Designation
 For the address number of 0 to 65535:
15
n+0
n+1
n+2
Expansion code
n+3
* If [Transmission Mode: Data Area Division] is set under [Communication Setting], specify a program number ([PRG No.])
for the expansion code.
Specify the number obtained by subtracting "1" from the actual program number ([PRG No.]) as defined below.
PRG No. 1: 0
PRG No. 2: 1
PRG No. 3: 2
8 7
Model Device type
Address No.
*
Bit designation
00 Station number
 For the address number of 65536 or greater:
0 15
n+0 Model
n+1
n+2
n+3
Expansion code
n+4
Example: 1: D0000
Address number
Device type
PRG No.: 1 to 3
8 7
Device type
Lower address No.
Higher address No.
*
Bit designation
00 Station number
0