Fuji Electric Monitouch V9 Series Connection Manual page 72

$Pn: 356 to 451
This device memory is valid when an Omron ID controller (V600/620/680) is connected with [Guarantee synchronism of the
data] checked on the [Device Memory Map Setting] dialog.
 Status ($Pn 356, 359, ...)
The execution status of the device memory map is stored here.
The bit is set (ON) when reading or writing of the first data in the device memory map is correctly finished.
When the control device memory (command bit) is set (ON), the bit is reset.
15 14 13 12 11
0 0 0 0 0
 Error code 1 ($Pn 357, 360, ...)
An error code is stored when an error occurs in the reading or writing of data in the device memory map.
If multiple errors occur in the device memory map, the last error code is stored.
When the control device memory (command bit) is set (ON), the bit is reset.
Code (HEX)
FFFFH Time-out
8001H Check code error
8002H Data error
800BH Receives the error code from the connected device
Errors other than the above are stored as shown below.
MSB
15 14 13 12 11
Overrun error
Framing error
Break detection
Error
0: Bits 0 to 14 are all "0".
1: Any bit from 0 to 14 is other than "0".
 Error code 2 ($Pn 358, 361, ...)
The exit code is stored here when "800BH" of error code 1 is stored.
Exit Code (HEX)
10
11
12
Host communication error
13
14
18
70
71
72
76 Slave communication error
7A
7C
7D
75
Tag device memory
warning
76
92
System error
93
1.5 System Device Memory for Communication Confirmation
10 9 8 7 6 5
0 0 0 0 0 0
System reserve
10 9 8 7 6 5
0 0 0 0 0
Buffer-full error
Parity error
Parity error
Framing error
Overrun error
FCS error
Format error, execution status error
Frame length error
Tag communication error
Inconsistency error
Tag absence error
Copy error
Address error
Antenna disconnection error
Write protect error
Data check command
Exit code stored when the writing count management command has been
successfully processed (without any error)
Data check command
Exit code stored when the writing count management command has abnormally
been processed (comparison error, excessive writing counts)
Abnormal mains voltage at antenna
Internal device memory error
4 3 2 1 0
0 0 1 0 0
1: ID tag recognized
Contents
LSB
4 3 2 1 0
0 0 0 0 0
Contents
1-61