L Series (Built-In Ethernet) - Fuji Electric Monitouch V9 Series Connection Manual

9.1.18 L Series (Built-in Ethernet)

Communication Setting
Editor
Make the following settings on the editor. For more information, see "1.3.2 Ethernet Communication".
 IP address for the V9 unit
- When specified on the screen program:
[System Setting]  [Hardware Setting]  [Local Port IP Address]
- When specified on the V9 unit:
Local mode  [LAN Setting]
 Port numbers 1024 to 65000 for the V9 unit (for communication with PLC)
[System Setting]  [Hardware Setting]  [PLC Properties]  [Communication Setting]
 IP address and port number of the PLC
Register on the [PLC Table] in [System Setting]  [Hardware Setting]  [PLC Properties]  [Target Settings].
9.1 PLC Connection
Setting range: 1024 to 65000
In addition to the specified port number, the port
number of "the specified port number +20" is
secured by the system.
Example: When specifying port number 10001,
the port number 10021 is also used.
Take care not to use the same port numbers with
other settings.
Valid only for 1 : 1 connection
Select the PLC for connection from those
registered on the PLC table.
Set the IP address, port number and
whether or not to use the KeepAlive
function of the PLC.
9-31