Ma900 / Ma901 (Modbus Rtu) - Fuji Electric Monitouch V9 Series Connection Manual

16-8 16. RKC

16.1.6 MA900 / MA901 (MODBUS RTU)

Communication Setting
Editor
Communication setting
Item
Connection Mode
Signal Level
Baud Rate
Data Length
Stop Bit
Parity
Target Port No.
MA900/MA901
Setup setting mode
When the [R/S] key is pressed while the [SET] key is held down in the PV/SV monitor mode, the controller enters in the "setup
setting" mode.
Indication
Add Slave address
bPS Baud rate
bIT Data configuration
InT Interval time setting
Available Device Memory
The available setting range of device memory varies depending on the controller model. Be sure to set within the range
available for the controller to be used. Use [TYPE] when assigning indirect device memory for macro programs.
Device Memory
---
Setting
1 : 1 / 1 : n / Multi-link2 /
Multi-link2 (Ethernet) /
1 : n Multi-link2 (Ethernet)
RS-232C / RS-422/485
4800 / 9600 / 19200 bps
8 bits
1 bit
None / Odd / Even
1 to 31
Item Setting
1 to 31
1: 4800 bps
2: 9600 bps
3: 19200 bps
0: 8 bits / 1 bit / none
2: 8 bits / 1 bit / even
4: 8 bits / 1 bit / odd
0 to 250 msec
TYPE
00H
Remarks
Remarks
Communication is not performed when "0" is set.
Remarks
(Underlined setting: default)
(Underlined setting: default)