Appendix A - Optional Configuration Methods; Configuring The Ts-850I As An Analog Local Extension; Activate Extension Area - Talkswitch TS-850i User Manual

APPENDIX A — OPTIONAL
CONFIGURATION METHODS

Configuring the TS-850i as an analog local extension

Once you have completed the procedures in Installing the TS-850i on page 7, you
can configure the TS-850i as an analog local extension. The base will support one
extension. If multiple handsets are registered with the base, they will share the
extension. Calling the extension will ring all handsets, but only one handset can
be used at a time.
If the TS-850i is configured as an analog local extension, you must engage Flash
to hold, transfer and park calls; to answer call waiting and queued calls; and to
get an internal dial tone if direct line access is enabled. To engage Flash, press the
R # key for approximately two seconds until you receive dial tone or connect to
the other caller.
1. Connect the telephone cable from the Line port on the base to the E1–E8 jack
on the TalkSwitch unit.
2. If possible, connect the Ethernet cable from the WAN port on the base to a
LAN port on your router or Ethernet switch. This will prevent the "No IP
address" message from appearing.
3. Launch the TalkSwitch management software.
4. Select the Local Extensions/Fax page.
5. Select an available extension number.

Activate Extension area

1. Ensure the Activate extension check box is selected.
4 8 T S - 8 5 0 i U S E R G U I D E