Appendix A - Optional Configuration Methods; Configuring The Ts-850I/Ts-860I As An Analog Local Extension - Talkswitch TS-860i User Manual

APPENDIX A — OPTIONAL
CONFIGURATION METHODS

Configuring the TS-850i/TS-860i as an analog local extension

Once you have completed the procedures in Installing the TS-850i/TS-860i on page
7, you can configure the TS-850i/TS-860i as an analog local extension. The base
will support one extension. If multiple handsets are registered with the base, they
will share the extension. Calling the extension will ring all handsets, but only one
handset can be used at a time.
If the TS-850i/TS-860i is configured as an analog local extension, you must engage
Flash to hold, transfer and park calls; to answer call waiting and queued calls; and
to get an internal dial tone if direct line access is enabled. To engage Flash, press
the R# key on the TS-850i or the
seconds until you receive dial tone or connect to the other caller.
1. Connect the telephone cable from the Line port on the base to the E1–E8 jack
on the TalkSwitch unit.
2. If possible, connect the Ethernet cable from the WAN port on the base to a
LAN port on your router or Ethernet switch. This will prevent the "No IP
address" message from appearing.
3. Launch the TalkSwitch management software.
4. Select the Local Extensions/Fax page.
5. Click the Add button. The Add User / Extension window appears.
5 0
key on the TS-860i for approximately two
T S - 8 5 0 i A N D T S - 8 6 0 i U S E R G U I D E