Brocade Communications Systems Brocade 8/12c User Manual page 559

5. Select the encryption engine (blade or switch) to configure, then click Next.
FIGURE 225
6. Click Next.
Brocade Network Advisor SAN User Manual
53-1002167-01
The list of engines depends on the scope being viewed.
•
If the Targets dialog box is showing all targets in an encryption group, the list includes all
engines in the group.
•
If the Targets dialog box is showing all targets for a switch, the list includes all encryption
engines for the switch.
•
If the Targets dialog box is showing targets for a single encryption engine, the list contains
only that engine.
The Select Target dialog box displays
target nodes in the same fabric as the encryption engine. The Targets in Fabric table does not
show targets that are already configured in an encryption group.
You can select targets from the list of known targets, or manually enter the port and node
WWNs.
Select Target dialog box
a. Select a target from the list. (The Target Port WWN and Target Node WWN fields contain all
target information that displays when using the nsshow command.) You can also enter
WWNs manually, for example, to specify a target that is not on the list.
b. Select a target type from the Type list. If the target node is disk storage, choose Disk. If the
target node is tape storage, choose Tape.
The Select Hosts dialog box displays
same fabric as the encryption engine.
Adding encryption targets
(Figure 225). The dialog box lists all target ports and
(Figure 226). The dialog box lists all hosts that are in the
18
515