Assigning A Dcb Map To A Port Or Link Aggregation Group - Brocade Communications Systems Brocade 8/12c User Manual

14
QoS configuration

Assigning a DCB map to a port or link aggregation group

A port can have either a DCB map or a Traffic Class map assigned to it, but it cannot have both.
1. Select Configure > DCB from the menu bar.
2. Select a port or LAG, and click Edit.
3. Click the QoS tab on the Edit Port dialog box.
4. Click the Assign a map check box.
5. Select DCB Map in the Map Type list.
6. Select a DCB Map in the Available DCB Maps list.
7.
356
The DCB Configuration dialog box displays, showing the status of all DCB-related hardware and
functions.
The QoS dialog box displays.
FIGURE 125
QoS, Assign a DCB Map to a port dialog box
If you do not enable this check box, all QoS edit features are disabled.
If no DCB maps were created on the switch, the Available DCB Maps list is empty.
When you have finished the configuration, click OK to launch the Deploy to Ports/LAGs dialog
box, shown in Figure 134.
Brocade Network Advisor SAN User Manual
53-1002167-01