Adding Target Tape Luns For Encryption - Brocade Communications Systems StoreFabric SN6500B Administrator's Manual

Brocade fabric os encryption administrator's guide v7.1.0 (53-1002721-01, march 2013)
Hide thumbs Also See for StoreFabric SN6500B:
Table of Contents

Advertisement

Adding target tape LUNs for encryption

You can configure a Crypto LUN by adding the LUN to the CryptoTarget container and enabling the
encryption property on the Crypto LUN. You must add LUNs manually. After you add the LUNs, you
must specify the encryption settings.
When configuring a LUN with multiple paths, the same LUN policies must be configured on all
paths to the LUN. If there are multiple paths to the same physical LUNs, then the LUNs are added
to multiple target containers (one target per storage device port).
1. Select Configure > Encryption from the menu task bar to display the Encryption Center
2. Select a group, switch, or engine from the Encryption Center Devices table that contains the
FIGURE 50
3. Select a target tape storage device from the Encryption Targets table, then click LUNs.
Fabric OS Encryption Administrator's Guide (SKM/ESKM)
53-1002721-01
dialog box (Refer to
Figure 1
storage device to be configured, then select Group/Switch/Engine > Targets from the menu
task bar.
NOTE
You can also select a group, switch, or engine from the Encryption Center Devices table, then
click the Targets icon.
The Encryption Targets dialog box displays
add LUNs manually.
Encryption Targets dialog box
The Encryption Target Tape LUNs dialog box displays

Adding target tape LUNs for encryption

on page 14).
(Figure
50). Initially, the table is empty. You must
(Figure
51).
2
75

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the StoreFabric SN6500B and is the answer not in the manual?

This manual is also suitable for:

Fabric os 7.1.0

Table of Contents