Cisco SR2016T-NA Reference Manual page 158

cable logging layer2events
cable logging layer2events
To save selected (low priority) DOCSIS events that are specified in CMTS MIB Registry to the cable
logging buffer (instead of to the general logging buffer), use the cable logging layer2events command
in global configuration mode. To disable the logging of DOCSIS events to the cable logging buffer, use
the no form of this command.
Syntax Description This command has no additional arguments or keywords.
Defaults
DOCSIS events are saved to the general logging buffer on the Cisco CMTS by default.
Command Modes Global configuration mode
Command History Release
12.3(9a)BC
Usage Guidelines Use the show cable logging command to check whether the logging feature is enabled and the status of
the logging buffer.
Examples
The following example shows how to clear the log buffer that contains a bad IP source address error
messages:
Router# show cable logging summary
Cable logging: BADIPSOURCE Enabled
Total buffer size (bytes): 1000000
Used buffer size (bytes) : 36968
Logged messages : 231
Router# clear cable logging badipsource
Router# show cable logging summary
Cable logging: BADIPSOURCE Enabled
Total buffer size (bytes): 1000000
Used buffer size (bytes) : 0
Logged messages : 0
Related Commands Command
cable logging badipsource
show cable logging
Cisco Broadband Cable Command Reference Guide
2-146
cable logging layer2events
no cable logging layer2events
Modification
This command was introduced on the Cisco uBR10012 and
Cisco uBR7246VXR universal broadband routers.
Description
Logs error messages about bad IP source addresses on the cable
interfaces to a separate log buffer,
Indicates whether the logging feature is enabled and the status of the
logging buffer.
Chapter 2 Cisco CMTS Configuration Commands
OL-1581-08