Table of Contents
Advertisement
Chapter 2
Cisco CMTS Configuration Commands
cable modem access-group
To configure the access-group for a CM, use the cable modem access-group command in privileged
EXEC mode. To disable the specification, use the no access-group form of this command.
The cable modem access-group command is not supported on the Cisco uBR10012 universal
Note
broadband router.
Syntax Description
ip-addr
mac-address
access-list
access-name
Defaults
No default behaviors or values
Command Modes
Privileged EXEC
Command History
Release
11.3(8) NA
12.2(4)BC1
Examples
The following example shows the cable modem access-group command assigning access-list 1 to the
CM with the MAC address of abcd.ef01.2345:
Router# cable modem abcd.ef01.2345 access-group 1
Router#
Related Commands
Command
cable host access-
group
cable modem change-
frequency
OL-1581-08
cable modem {mac-addr | ip-addr} access-group [access-list | access-name]
cable modem {mac-addr | ip-addr} no access-group
Modification
This command was introduced.
The functionality of this command was made identical to that of the
host access-group
backwards compatibility.
Description
Configures the access list for a host.
Changes the downstream frequency or upstream channel ID.
Specifies the IP address for the CM.
Specifies the MAC address for the CM.
Specifies the IP access list (standard or extended). Valid values are 1
to 199.
Specifies the access-list name.
command, but both commands were retained for
Cisco Broadband Cable Command Reference Guide
cable modem access-group
cable
2-153
Advertisement
Table of Contents
