Table of Contents
Advertisement
Chapter 2
Cisco CMTS Configuration Commands
Examples
The following example shows how to force baseline privacy to be used for all CMs on a particular cable
interface:
Router(config)# interface cable 3/1
Router(config-if)# cable privacy mandatory
The following example shows how to turn on the baseline privacy interface (BPI) modem authentication
for an interface:
Router(config)# interface cable 5/1/1
Router(config-if)# cable privacy authenticate-modem
The following example shows how to turn on BPI multicast authorization on a particular cable interface:
Router(config)# interface cable 1/0
Router(config-if) cable privacy authorize-multicast
The following example shows how to allow CMs to register with self-signed certificates on a particular
cable interface:
Router(config)# interface cable 7/1/0
Router(config-if) cable privacy accept-self-signed-certificate
The cable privacy accept-self-signed-certificate command affects only those CMs that register after
Note
you give the command. For example, if you give the no cable privacy accept-self-signed-certificate
command so that CMs cannot register using self-signed certificates, you must then issue the clear cable
modem all reset command to force all CMs reregister using certificates that are chained to the DOCSIS
root certificate.
Related Commands
Command
cable privacy add-
certificate
cable privacy hotlist
cable privacy kek
cable privacy tek
option
show cable privacy
debug cable privacy
OL-1581-08
Description
Adds CM certificates for BPI+ encryption.
Adds a CM certificate to the DOCSIS hotlist so that it is no longer accepted.
Sets key encryption keys and timeout periods.
Sets traffic encryption keys and timeout periods.
Determines whether a specific CM is online.
Displays information about BPI status and operation.
Displays debug messages for BPI operation.
Cisco Broadband Cable Command Reference Guide
cable privacy
2-183
Advertisement
Table of Contents
