Cisco SR2016T-NA Reference Manual page 198

cable privacy hotlist
cable privacy hotlist
To mark a manufacturer's or CM certificate as untrusted and add them to the CMTS hotlist of invalid
certificates, thereby preventing those CMs from registering, use the cable privacy command in global
configuration mode. To remove a particular CM or manufacturer's certificate from the hotlist, use the no
form of this command.
Syntax Description cm mac-address
manufacturer cert-serial-
number
Defaults
The CMTS hotlist does not contain any certificates.
Command Modes Global configuration
Command History Release
12.1(7)CX,
12.2(1)XF1,
12.2(4)BC1
12.2(11)BC1
12.2(15)BC2
Usage Guidelines This command is applicable only on images that support BPI or BPI+ encryption.
The cable privacy hotlist command is not supported on the Cisco uBR10012 router. To add a
Note
manufacturer's or CM certificate to the hotlist on the Cisco uBR10012 router, use SNMP commands to
set the appropriate attributes in DOCS-BPI-PLUS-MIB. For more information see the
DOCSIS 1.1 on the Cisco CMTS
Cisco Broadband Cable Command Reference Guide
2-186
cable privacy hotlist {cm mac-address | manufacturer cert-serial-number}
no cable privacy hotlist {cm mac-address | manufacturer cert-serial-number}
Modification
This command was introduced for the Cisco uBR7100 series and
Cisco uBR7200 series routers.
The accept-self-signed-certificate option was moved to the
cable interface command.
The mac-address can be specified in the canonical form of three pairs of
hexadecimal digits, separated by periods (for example, 0000.0001.0002).
Specifies the MAC address for the CM certificate to be added to the
hotlist. The mac-address should be specified as a hexadecimal string,
without periods or other separators. In Cisco IOS Release
12.2(15)BC2 and later releases, you can also specify it as three sets of
hexadecimal digits, separated by periods.
Specifies the serial number for the particular manufacturer CA
certificate. The cert-serial-number should be specified as a
hexadecimal string up to 32 bytes in length. Enter multiple lines as
needed, and use a blank line to terminate the string.
chapter in the CMTS Feature
Chapter 2 Cisco CMTS Configuration Commands
cable privacy
Configuring
Guide.
OL-1581-08