Table of Contents
Advertisement
Chapter 2
Cisco CMTS Configuration Commands
Router(config)# cable logging badipsource 8192
Router(config)# exit
Router# show cable logging badipsource
<<buffer contents omitted>>
Router# configure terminal
Router(config)# cable logging badipsource 256000
The following example shows how to stop the logging of bad IP source address error messages to a
separate buffer. This clears out all error messages from the buffer and removes the buffer from memory,
and future error messages for bad IP source addresses are logged to the console or to the current system
log, if any.
Router# configure terminal
Router(config)# no cable logging badipsource
Router(config)#
Related Commands
cable source-verify
clear cable logging
show cable logging
OL-1581-08
Enables verification of IP addresses for CMs and CPE devices on the
upstream.
Removes all error messages about bad IP source addresses on the
cable interfaces from the error log buffer.
Displays the log of error messages about bad IP source addresses on
the cable interfaces.
Cisco Broadband Cable Command Reference Guide
cable logging badipsource
2-145
Advertisement
Table of Contents
