Important Safety Instructions; Additional Safety Instructions For Installation Personnel; Save These Instructions - Lucent Technologies PARTNER Advanced Communications System Installation Manual

Important Safety Instructions

The following list provides basic safety precautions that should always be followed when using
your telephone equipment:
1. Read and understand all instructions.
2. Follow all warnings and instructions marked on the product.
3. Unplug all telephone connections before cleaning. DO NOT use liquid cleaners or aerosol
cleaners. Use a damp cloth for cleaning.
4. This product should be serviced by (or taken to) a qualified repair center when service or
repair work is required.
5. DO NOT use this product near water—for example, in a wet basement location.
6. DO NOT place this product on an unstable cart, stand, or table.
7. Never push objects of any kind into slots or openings as they may touch dangerous voltage
points or short out parts that could result in a risk of fire or electric shock. Never spill liquid
of any kind on the product.
8. DO NOT use the telephone to report a gas leak in the vicinity of the leak.
9. The product is provided with a three-wire grounding type plug. This is a safety feature. DO
NOT defeat the safety purpose of the grounding type plug. DO NOT staple or otherwise
attach the power supply cord to building surfaces.
!
CAUTION:
DO NOT block or cover the ventilation slots or openings; they prevent the
product from overheating. DO NOT place the product in a separate enclosure
unless proper ventilation is provided. DO NOT place the product flat on a
surface. The control unit must be wall-mounted.
Additional Safety Instructions for
Installation Personnel
1. DO NOT Install telephone wiring during a lightning storm.
2. DO NOT Install telephone jacks in a wet location unless the jack is specifically designed
for wet locations.
3. Never touch uninsulated telephone wires or terminals unless the telephone line has been
disconnected at the network interface.
4. Use caution when installing or modifying telephone lines.
5. The control unit must be securely wall mounted.
!
CAUTION:
If any wiring from the extension jacks leaves the building premises, you must
install Lucent Technologies
Building Extensions").
!
CAUTION:
Use only Lucent Technologies-manufactured PARTNER modules in the
PARTNER Advanced Communications System.
!
CAUTION:
Environmental and electrical conditions must meet the requirements as listed in
"Specifications".
TM
IROB protectors (see "Requirements for Out-of

SAVE THESE INSTRUCTIONS