Table of Contents
Advertisement
Touch-Tone Enable (F08)
Description
This feature is available only on system phones.
This feature lets a system phone user send touch-tone signals on an outside call
over a rotary line. For example, a user may need to dial touch-tone digits while
on a call to a bank-by-phone service.
Related Procedures
You must use Dial Mode (#201) to identify rotary lines to the system.
To activate this feature from within a number stored on an Auto Dial button
or as part of a Speed Dial number, press [
number—see Special Dialing Functions.
Considerations
This feature is needed only when dialing on a rotary line.
Use Touch-Tone Enable only after a call is connected. For example, use
this feature after dialing a bank-by-phone service that requires you to dial
touch-tone digits.
You can program a Touch-Tone Enable button on a system phone to turn on
Touch-Tone Enable with one touch.
Programming
To program a Touch-Tone Enable button:
1.
Press [
Feature
2.
Enter the number of the extension to be programmed with this feature.
3.
Press a programmable button.
4.
Press [
Feature
5.
Program another button for this extension or exit programming mode.
Using
From a system phone, press the programmed button or press [
when you need to dial touch-tone digits. Touch-Tone Enable stays in effect until
you hang up.
] [
] [
] [
] [
0
0
System Program
System Program
] [
] [
].
0
8
] when storing the
Transfr
] [
].
Central Tel Program
] [
Feature
Touch-Tone Enable (F08)
] [
]
0
8
5-187
Advertisement
Chapters
Table of Contents
