Changing Calling Group Assignments - Lucent Technologies MERLIN LEGEND System Manager's Manual

MERLIN LEGEND Communications System Release 5.0
System Manager's Guide 555-650-118
6 Managing the System

Changing Calling Group Assignments

For a voice messaging system and auto attendant:
Console Procedure
PC Procedure
For the other auxiliary equipment noted above:
Console Procedure
PC Procedure
Changing Calling Group Assignments
Use this procedure to assign or remove an extension from a calling group.
Planning Guidelines
An extension can belong to only one calling group. A QCC cannot be a member of
a calling group. A delay announcement device should not be programmed as a
calling group member.
A calling group can be a Night Service group member.
The total number of extensions can be divided into a maximum of 32 calling
groups. A calling group can include a maximum of 20 extensions, but not all 32
calling groups can have this maximum number.
If a linear hunting pattern is indicated on the back of the system planning form
(7d), be sure to assign extensions to the group in the exact order that they are
shown on the form. The system searches for an available member in the order in
which you assign the extensions to the group.
The Extension Status feature must be set to the calling group or CMS mode
before you assign members to the group. For more information, see "Extension
Status" in the Feature Reference and in the "System Features" section of Chapter
3, System Programming .
Changing calling group assignments may affect other features; for more
information, see the Feature Reference .
AuxEquip VMS/AA
rings
Enter TT Duration
Enter TT Interval
Enter Exit Exit
% "  3
Type no. of ms
+
 3
+ Type no. of ms
3
AuxEquip MusicOnHold
Dial line/trunk no.
MaintAlarms
Type line/trunk no.
% 
Drop
TransferRtn
Drop Dial no. of ms
Drop Dial no. of ms
Type no. of rings
+
 
 ! !
or or
Ldspkr Pg
Enter
 !
6
6
Issue 1
June 1997
Page 6-68
Dial no. of

Exit