Report Formats - Ricoh fax4700l Operator's Manual

REPORTS
Communication Failure Report (ON if Transmission Result Report is OFF)
This report is printed if a memory transmission failure occurred, after a job is
completed. It is only printed if the Transmission Result Report is switched off.
Error Report (Turned on/off by a Service Technician)
This report is printed after each unsuccessful communication. The communication
failure report (above) is printed after a job has been completed. So while doing a
broadcast, the machine may print a number of error reports, and at the end, it
prints a communication failure or transmission result report. Check it, and
retransmit any pages that were not sent. If a particular problem continues or gets
worse, keep the error reports for the service technician.
Printing Part of the Image on the Report (Switch 04, bit 7)
For reference purposes, the machine prints the first few inches of the fax
message on the following reports.
Transmission Result Report
Memory Storage Report
Communication Failure Report

Report Formats

Example 1. Error Report*
* * *
FILE
---------------------------------------------------------------------
Example 2. TCR*
* * *
<TX>
DATE TIME
--------------------------------------------------------------------
<RX>
DATE TIME
-------------------------------------------------------------------
The Mode Column
See the bottom of the TCR for a full listing of symbols on the TCR. On other
reports a code is given, informing the type of communication. These codes are
explained below.
ERROR REPORT (AUG 01 1995 -06:00 AM)
ADDRESS
Report details appear here
TCR (AUG 01 1995 07:00AM) * * *
ADDRESS MODE
Transmission details appear here
ADDRESS MODE
Reception details appear here
AUTOMATICALLY PRINTED REPORTS
* * *
TTI XYZ COMPANY
MODE TIME PAGE
TTI XYZ COMPANY
TIME PAGE RESULT
TIME PAGE RESULT
RESULT
FILE
FILE
173