Ricoh fax4700l Operator's Manual page 524

5. Change the paper size plate (located at
the front of the cassette).
To remove an existing plate, squeeze the
two vertical tabs slightly inwards while
pulling the plate out from below (see dia-
gram). Insert a plate with the appropriate
paper size engraved on the front.
6. Fit the paper fence lock behind the rear
fence of main cassette as shown in the
diagram. The lock should fit into the slots
on the base of the tray and should be
snug against the paper fence. Insert the
holding pin as shown and fix the plastic
nut, under the tray.
7. Fan the paper. Make sure the edges are
uniformly aligned and place the paper
into the cassette with the side on wish
you wish to print face up. Check the pa-
per fits under the metal corners.
Do not fill up the cassette past the load
limit marker.
8. If there is space between the paper and
fences, the paper will not be fed properly.
To avoid this, carefully move in each
fence until it is flush with the paper.
9. Replace the cassette to its original posi-
tion.
LOOKING AFTER THE MACHINE
[Main Cassette]
[Optional front cassette]
179